Bespoke concrete wet-edge pools engineered for raised and sloping sites right across the Coffs Harbour area.
Infinity and wet-edge pools are defined by a single engineered detail: an edge set just below the waterline so the pool appears to merge with the horizon. Water continuously flows over that edge into a hidden catch basin, where it is collected and pumped back into the pool, and maintaining an even sheet of water over the lip is the whole craft of Infinity & Wet-Edge Pools. This is why these pools are always bespoke concrete builds and why the level of the overflow edge has to be controlled to very fine tolerances. The construction process is the full concrete program: structural engineering for the site, certifier or council approval, excavation, steel reinforcement and plumbing, the sprayed shell, then the catch basin, the balance tank that buffers the flow, the recirculation pump, and finally the interior and surrounds. A wet-edge design only delivers its effect where the Frederickton block gives the water somewhere to fall toward, so it suits raised lots, downslopes and New England and North West sites with an outlook; on a flat, enclosed yard the illusion is largely lost. The practical considerations for a Coffs Harbour owner are the extra plant and cost of the basin and second pump, the ongoing job of running two water systems, and above all the build precision, because an edge that is even slightly out shows up at once in the water line. Compliance is no different from any pool, with a conforming AS 1926.1 barrier and a pool-register listing required. With careful engineering and an experienced crew across Coffs Harbour, an infinity pool becomes the element that organises the entire outdoor design of a Frederickton home around the view it was built to capture.
Bespoke concrete pools for Frederickton, with infinity edges, beach entries and split levels that prefabricated shells simply cannot match.
Pre-moulded fibreglass shells with a smooth, durable gelcoat finish, installed right across Frederickton and the Coffs Harbour area.
Deep, small-footprint plunge pools for tight inner-Coffs Harbour blocks, built in either concrete or fibreglass to fit the space exactly.
Long, slender lap pools that turn a narrow Frederickton side yard into a private space for daily fitness swimming.
Bespoke concrete wet-edge pools engineered for raised and sloping sites right across the Coffs Harbour area.
Compact pools designed to make the very most of small Frederickton terraces, side spaces and enclosed courtyards.
Renovation that brings a dated, leaking or tired Frederickton pool back to life for far less than a full rebuild.
Refinish a rough or stained Frederickton pool, seal minor surface leaks and cut down on chemical use.